LG 32LH500B Manual Del Proprietário página 5

• This apparatus uses batteries. In your community
there might be regulations that require you
to dispose of these batteries properly due to
environmental considerations. Please contact
your local authorities for disposal or recycling
information.
• The battery (battery or batteries or battery pack)
shall not be exposed to excessive heat such as
sunshine, re or the like.
• Do not short circuit, disassemble, or allow the
batteries to overheat.
• This equipment is a Class
electrical appliance. It has been designed in such a
way that it does not require a safety connection to
electrical earth.
• Do not use high voltage electrical equipment
near the TV. (e.g., a bug zapper.)
This may result in product malfunction.
• Dot Defect
The panel is a high technology product with
resolution of two million to six million pixels.
In a very few cases, you could see ne dots on
the screen while you're viewing the TV. Those
dots are deactivated pixels and do not a ect the
performance and reliability of the TV.
• Generated Sound
Cracking noise A cracking noise that occurs
when watching or turning o the TV is
generated by plastic thermal contraction due to
temperature and humidity. This noise is common
for products where thermal deformation is
required.
Electrical circuit humming/panel buzzing
A low level noise is generated from a high-
speed switching circuit, which supplies a large
amount of current to operate a product. It varies
depending upon the product. This generated
sound does not a ect the performance and
reliability of the product.
• Take care not to touch the ventilation openings.
When watching the TV for a long period, the
ventilation openings may become hot. This does
not a ect the performance of the product or
cause defects in the product.
• Do not install this product on a wall if it could be
exposed to oil or oil mist. This may damage the
product and cause it to fall.
• If the TV feels cold to the touch, there may
be a small icker when it is turned on. This is
normal; there is nothing wrong with TV. Some
minute dot defects may be visible on the screen,
appearing as tiny red, green, or blue spots.
However, they have no adverse e ect on the TV's
performance. Avoid touching the LCD screen or
holding your nger(s) against it for long periods
of time. Doing so may produce some temporary
distortion e ects on the screen.
or double insulated
Ⅱ
Preventing Image Burn or Burn-in on
Your TV Screen
• Displaying a still image for a prolonged period of
time may cause image sticking.
Avoid displaying a xed image on the TV screen
for a long period of time.
FCC NOTICE
(For USA)
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment o and on, the user is encouraged
to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and the receiver.
- Connect the equipment to an outlet on a circuit
di erent from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV
technician for help.
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference and (2) this device must accept any
interference received, including interference that
may cause undesired operation of the device. Any
changes or modi cations in construction of this
device which are not expressly approved by the
party responsible for compliance could void the
user's authority to operate the equipment.
5