Assembly And Adjustment - BLACK&DECKER Li4000 Manual De Instrucciones

Destornillador de 3,6 v con sujetador de tornillos retráctil
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

90531282 Li4000.qxd
does occur, release the trigger immediately and determine the reason for the stall before
re-starting.

ASSEMBLY AND ADJUSTMENT

WALL MOUNTING THE CHARGING CRADLE (FIGURES A, B)
The charging cradle can be placed on a level surface or mounted to a wall. Use the
hardware provided only if hanging on conventional sheet rock or plaster walls. If not
hanging on conventional sheet rock or plaster walls, please use the appropriate
fasteners for that material.
• Choose a location that is within reach of an electrical outlet.
• If wall mounting, space mounting screws the same distance apart (3 inches 75mm) as
the slots on the back of the charger shown in figure A. NOTE: Avoid damaging the cord
while fixing the charging cradle (10) to the wall.
• Plug in charger and place the product in position (figure B). Make sure the charge
indicator light (9) is on. If the indicator light is not on, adjust unit to make sure charging
contacts (8) are touching.
INSERTING AND REMOVING BITS (FIGURE C)
• To install a bit simply insert it into the cavity in the hex spindle (6) as shown in figure C.
To remove the bit pull it straight out.
TORQUE CONTROL (FIGURE D)
Your screwdriver is equipped with a six position clutch collar (4). When the tool reaches the
preselected torque setting the clutch slips, thus limiting how tightly a screw is driven.
• The tool's motor will continue to run as long as the switch button is depressed.
• To set the tool's torque, rotate the adjustable clutch collar (4) clockwise or
counterclockwise as required (figure D). The larger the screw icon, the higher the torque.
Each click in a clockwise direction (facing the spindle ) means an increase in the torque
produced.
FORWARD / REVERSE / LOCK OFF SLIDER (FIGURE E)
• To select forward or reverse rotation, use the forward / reverse slider (2) (see arrows on
the slider). A window (3) on the top of the unit will display the rotating direction with an
arrow (figure E).
NOTE: When the forward / reverse slider is in the central position the tool is locked off to
prevent accidental actuation or battery discharge.
OPERATING INSTRUCTIONS
SWITCHING ON AND OFF
• To run the tool, press the switch (1).
• To stop the tool, release the switch.
• To lock the tool in the off position, move the forward / reverse slider (2) to the central
position.
SCREW DRIVING
• Insert the appropriate screwdriver bit into the hex spindle.
• Select forward or reverse rotation.
• Set the clutch collar to the smallest screw icon and begin driving screw (low torque).
• If the clutch ratchets too soon, adjust the clutch collar to increase the torque as required.
SCREW DRIVING USING THE BUILT-IN SCREW HOLDER (FIGURES F - I)
The screw holder (7) can be used with both one and two inch screwdriver bits. It cannot
be used with bit tip holder extensions.
To use the screw holder:
• Grasp the screw holder carrier and pull it out from the screwdriver. (figure F)
• Place desired screw onto screw holder carrier (figure G). Ensure screw threads rest on
screw carrier as shown.
• Slide screw holder arm back towards screwdriver bit. Ensure screwdriver bit tip and
screw head are fully engaged. (figure H)
• At this time the screw is being held securely to the screw holder carrier by means of an
4/15/08
11:07 AM
Page 9
9

Publicidad

Tabla de contenido
loading

Tabla de contenido