Implementing; Maintenance; Exchange Of Saw Blade; Troubleshooting - Scheppach wox d 700 Traducción De La Instrucción De Original

Implementation
• Please read the safety instructions before implementation.
• All protection and additional facilities should be fitted.
• The saw is exclusively constructed to cross cut firewood with a maximum length of 1 meter.
• Independent of the wood diameter only one piece should be laid on the rocker.
• Hold the wood with the left hand and use the rocker with the right hand.

Maintenance

•Modifying as well as adjusting, measuring and cleaning
to be carried out only when motor is switched off. Pull out
power plug!

Exchange of saw blade

• The exchange of the saw blade can only be undertaken
in
firewood cut position.
• Open side lid.
• wox d700: put the locking pen (1) through the bottom
saw blade protection to lock the saw blade.
• Loosen the saw blade with the supplied open-end
wrench / female six fold wrench (2).

TROUBLESHOOTING

To repair disfunctiones switch off the machine. Pull out power supply.
Cause
Upon switching off the saw does not slow down.
Brake board defect
Electrotechnical maintenance works should only be carried out by an electronics technician!
On removal of the machine the local legal regulations have to be abided by.
Seite:56
Remedy
Renew brake board
�
�
�
�