Tabla de contenido
Publicidad
Height Adjustable Operation Guide
NORMAL OPERATION
Raise or lower the desk by pressing and holding the up (^) and down (v) buttons until the desired height is reached.
INSTRUCTIONS FOR PROGRAMMING MEMORY POSITIONS
1‐ Press both the up (^) and down (v) buttons until the desired height.
2‐ Press the "M" button and hold until the number flashes.
3‐ Select to which memory the height will be associated by pressing the chosen number (1‐2‐3‐4), and now four
different heights position have been memorized.
Note: memorized positons will remain even if power is lost.
INSTRUCTIONS FOR USING MEMORY POSITIONS
To adjust the table to the heights stored in memory, press and hold the desired memory (1‐2‐3‐4) until the
height is reached.
INSTRUCTIONS FOR IMPERIAL AND METRIC SWITCHING
1‐ Initialized number reads in imperial.
2‐ Press the "1","2" and "M" buttons simultaneously for 5 seconds until "C‐I" flashes. Now release the buttons.
3‐ Press "1" button to show metric height.
4‐ Repeat step 2 and press "2" to show imperial height.
USB FUNCTIONS
Connect desired USB compatible device to USB port to charge.
Use the desk with actual technical parameters as shown in below.
Input Voltage
Output Voltage
Max Load
Load speed
Lift range
110‐240V
32V
120 kg / 264.6 lbs
30mm (1.2 inch) /s
74‐120cm / 29.1‐47.2 inch
Publicidad
Tabla de contenido
