Uline ADA Instrucciones De Ensamble página 2

Figure 1
Figure 2
Figure 3
PAGE 2 OF 6
ASSEMBLY INSTRUCTIONS
Right
Left
Underside
of Table
Underside
1-800-295-5510
1. Verify all parts are present before beginning.
Hardware is located in a white box.
2. Flip the tabletop upside down. Take one leg at a
time and loosely attach to the tabletop using one
bolt, one washer and one nut. The leg braces are
an inside mount. The legs are labeled left and right.
Match the legs to the left and right markings on
the underside of the table. Attach the two legs with
supports to opposite sides. (See Figure 1)
3. Insert the V brace with the umbrella brace facing
upward and loosely bolt to the corresponding
corners using one bolt, one washer and one nut.
(See Figure 2)
of Table
4. Flip the table upright and loosely attach the three
bench seats to the legs with the leg braces having
an inside mount. (See Figure 3)
5. Ensure the tabletop and bench seats are level, then
tighten each bolt, finishing with the V brace.
NOTE: H-2300 mounting hardware not
included.
uline.com
0321 IH-2672