Steren TIM-250 Manual De Instrucciones

Before using your new Steren Wireless door bell, please read this
instruction manual to prevent any damage.
Put it away in a safe place for future references.
IMPORTANT
• Install it in a dry place.
• Clean with a soft, dry cloth.
• Do not try to open the device, may cause damages and warranty will be
void.
• Do not expose to extreme temperatures.
HIGHLIGHTS
• Wireless.
• You don't need any cable, only batteries.
• 50 metres wide range.
• 32 tones.
CONTROLS
Door bell
1.- Ring button
Press to activate a tone in the receiver.
2.- battery compartment
Use it to install a 23A battery.
Receiver
1.- Speaker
Allows you to hear s door bell sound.
2.- In use indicator
Lights on when somebody press the door bell.
3.- Up / Down
Use it to select a tone.
4.- Lo / Med / Hi
- Select Lo to listen to the tone,
with low volume level.
- Select Med to listen to the
tone, with medium volume level.
- Select Hi to listen to the tone,
with high volume level.
5.- Battery compartment
Use it to install two AA
batteries.
BATTERY INSTALLATION
Receiver
1.- Remove the cover from the battery
compartment.
2.- Place two AA batteries (not included),
paying attention to polarity.
3.- Replace the cover.
Door bell
1.- Remove the cover from the battery
compartment, using a screwdriver, as
shown.
2.- Place one 23A type battery, paying
attention to polarity.
3.- Replace the cover.
1.- Place the receiver in a flat surface or hang it up using the right hole.
2.- To install the door bell, clean the surface where you want to install it (wall
or door).
3.- Remove one of the protectors of the sticker and stick it on the wall or
door. Press it slightly.
4.- Then, remove the second protector from the
sponge.
5.- Place the door bell over the sponge and press
slightly.
After installing the device, press the Ring button, then you will hear a tone
in the receiver.
To change the tone:
1.- Press Up / Down button to select a tone.
2.- After selection, drop the button.
3.- If you want to modify the volume level, use Lo / Med / Hi.
Receiver
Input: 3V - - - (2xAA)
Before using your new Electronic insect killer, please read this
Product design and specifications are subject to change
instruction manual to prevent any damage. Put it away in a
without previous notice.
2
1
This Steren product is warranted under normal usage against defects in
workmanship and materials to the original purchaser for one year from the
date of purchase.
1.- This warranty card with all the required information, invoice or purchase
ticket, product box or package, and product, must be presented when
warranty service is required.
2.- If the product stills on the warranty time, the company will repair it free
of charge.
3.- The repairing time will not exceed 30 natural days, from the day the
claim was received.
4.- Steren sell parts, components, consumables and accessories to
customer, as well as warranty service, at any of the addresses mentioned
later.
If the product has been damaged by an accident, acts of God, mishandling,
leaky batteries, failure to follow enclosed instructions, improper repair by
unauthorized personnel, improper safe keeping, among others.
a) The consumer can also claim the warranty service in the purchase
establishment.
b) If you lose the warranty card, we can reissue it, if you show the invoice
or purchase ticket.
Name of the retailer
Address
Product
Brand
Part number
Serial number
Date of delivery
In case your product fails or have questions, please contact your
nearest dealer. If you are in Mexico, please give a call to our Call
INSTALLING THE DOOR BELL
HOW TO USE
TONES
3
SPECIFICATIONS
Transmitter
Input: 12V - - - (1x23A)
Product: Wireless door bell
Part number: TIM- 250
Brand: Steren
WARRANTY
CONDITIONS
THIS WARRANTY IS VOID IN THE NEXT CASES:
RETAILER INFORMATION
Center. Call Center
01 800 500 9000
1