Tektronix Phaser 840 Manual De Instrucciones página 3

Overview
Repacking the Color
Printer and Its
Accessories
It is very important that you follow the correct repacking procedure before
shipping the color printer. Complete repacking is required. Failure to properly
repack the printer can damage the printer's internal components. You are
responsible for any shipping damage to the printer that results from improper
or inadequate packaging.
Repacking for shipment consists of four basic tasks. Each of these tasks is
explained in detail. If you have questions regarding any of the repacking
procedures, call the Tektronix Customer Support Hotline at 1-800-835-6100 , or
contact Tektronix online at www.tek.com/Color_Printers/support/
1.
Turn off the printer using the On/Off switch and then selecting Shut
Down For Moving Printer at the front panel.
2.
Remove the maintenance drawer, seal it in a plastic bag, and store the
tray on a flat surface. A used maintenance drawer leaks drum fluid if tipped.
3.
Make sure that the printer has completed its shut down before moving
the printer (after approximately 15 minutes, the front panel goes
blank); this allows the ink to solidify.
4.
Repack the printer and its accessories using Tektronix-approved
packing materials.
Repacking the Color Printer and Its Accessories
1