Tektronix Phaser 840 Manual De Instrucciones página 4

Turning off the printer
Removing the maintenance drawer
2
Phaser 840 and 850 Color Printers
C
A U T I O N
To avoid damaging the printer's internal components, always turn the printer
power off using the On/Off switch (this places the printhead in the proper
position for safe shipment). Failure to do so may result in damage to the
printer's internal components during shipment. Never turn off the printer by
pulling the power cord.
1. Use the rear-panel On/Off switch to turn off the printer.
2.
At the front panel, immediately select Shut Down For Moving
Printer (you have 4 seconds before the display goes blank).
The printer reports the shut down status and takes approximately
15 minutes to cool down. While it is cooling, it is recommended that
you remove the maintenance drawer (see the next topic).
C
A U T I O N
If you do not select Shut Down For Moving Printer , you must wait
30 minutes for the ink to solidify. Before moving the printer, always wait for the
ink to solidify or you may damage the printer.
C
A U T I O N
To avoid damaging the printer, always remove the maintenance drawer before
moving or shipping the printer. Never ship a partially used maintenance
drawer.
1.
Open the printer's front cover.
1239-58