ASROCK Fatal1ty Z170 Gaming-ITX/ac Serie Manual De Instrucciones página 27

USB 3.0 Header
(19-pin USB3_5_6)
(see p.1, No. 8)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, No. 17)
1. High Deinition Audio supports Jack Sensing, but the panel wire on the chassis
must support HDA to function correctly. Please follow the instructions in our
manual and chassis manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to
connect them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel
and adjust "Recording Volume".
Chassis Speaker Header
(4-pin SPEAKER1)
(see p.1, No. 12)
Chassis Fan Connectors
(4-pin CHA_FAN1)
(see p.1, No. 3)
(4-pin CHA_FAN2)
(see p.1, No. 5)
Vbus Vbus
Vbus IntA_PB_SSRX-
IntA_PA_SSRX- IntA_PB_SSRX+
GND
IntA_PA_SSRX+
GND IntA_PB_SSTX-
IntA_PA_SSTX-
IntA_PB_SSTX+
IntA_PA_SSTX+ GND
IntA_PB_D-
GND
IntA_PA_D- IntA_PB_D+
IntA_PA_D+
Dummy
1
OUT_RET OUT2_L
J_SENSE
MIC_RET OUT2_R
PRESENCE# MIC2_R
GN D MIC2_L
1
DUMMY SPEAKER
1
+5V DUMMY
FAN_SPEED_CONTROL 4
3
FAN_SPEED
FAN_VOLTAGE 2
GND 1
GND
FAN_VOLTAGE
CHA_FAN_SPEED
FAN_SPEED_CONTROL
Fatal1ty Z170 Gaming-ITX/ac Series
Besides six USB 3.0 ports
on the I/O panel, there
is one header on this
motherboard. Each USB
3.0 header can support
two ports.
his header is for
connecting audio devices
to the front audio panel.
Please connect the chassis
speaker to this header.
Please connect fan cables
to the fan connectors and
match the black wire to
the ground pin.
23