Cleaning And Maintenance - EUROM PAC 12 Folleto De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

Timer:

The Timer button allows you to automatically start or stop the air conditioner at a set time.

Automatic starting: the air conditioner is off. Press the timer button and choose the moment that

you would like it to start working using the temperature buttons: each time you press

'temperature up' the hour will increase, each time you press 'temperature down', the hour will

decrease. If, for example, the display shows 5 hours, the air conditioner will switch on in 5

hours.

Automatic stopping: the air conditioner is on. Press the timer button and choose the moment

that you would like it to stop working using the temperature buttons: each time you press

'temperature up' the hour will increase, each time you press 'temperature down', the hour will

decrease. If, for example, the display shows 2 hours, the air conditioner will switch off in 2

hours. The timer can be set to between 1 to 24 hours.

Water outlet

During the cooling process, the device removes water from the air. This largely evaporates but

any excess water is collected in the water

reservoir. If the water reservoir in the device

is full, the compressor and the motor will

stop automatically and the 'water tank full'

light (W.F.) will come on. In this event,

switch the air conditioning unit off and

remove the plug from the socket. Empty the

water tank by removing the cap from the

water drainage point (see picture) and

draining the tank into a drain or receptacle.

Do not forget to replace the cap again

afterwards! You can then switch the air

conditioning unit back on.

When dehumidifying, more water is

removed from the air. This is why you must connect a hose to the water drainage hose during

dehumidifying and run this to a drain (at a lower point).

Safety

The PAC12 / 14 is fitted with an overheating safeguard that switches the unit off if it overheats.

If this should occur, you must remove the plug from the socket and leave the PAC12 / 14 to cool

for at least 30 minutes. Remove the cause of overheating - has the device been (partially)

covered? Is it too close to a wall or another obstacle, preventing it sucking in or dispelling

sufficient air?

You can then use the device normally again but keep an eye on it for the first 30 minutes to

ensure there are no further problems. If the device is showing signs of problems or the

overheating recurs, even though there is no obvious assignable cause, ask your supplier or a

recognised electrician to check/repair the unit.