Care And Cleaning - LUND Latitude Nerf Instrucciones De Instalación

Installation Steps
Align the driver side nerf bar with the driver side front
mounting bracket and loosely attach using (2) bolt
Bolt assemblies
4
Check position of nerf board and ensure it is properly parallel
with rocker panel. Adjust as needed.
Fully tighten all bracket bolts and nuts.
6
Inspection After Installation
• Inspect all bolts and nuts for proper tightness.

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
• Do not use cleaning solvents of any kind.
Congratulations!
You have purchased one of the many quality Lund ® branded products offered by Lund International. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is
top quality in terms of fit, durability, finish and ease of installation.
™
NOTE: Actual application may vary slightly from illustrations.
assemblies.
Nerf bar
Figure 4
Figure 6
Lund International
800-328-2438 • Visit us at lundinternational.com
© 2018 Lund, Inc. All rights reserved.
Lund and the Lund
®
Repeat Step 4 to attach the nerf bar at the middle and rear bracket
5
Rotate bar until step pad surface is level. and tighten all hardware.
Repeat steps for passenger side installation.
7
The material that your product is made from can
be recycled. Please also consider recycling the
logo are trademarks of Lund, Inc.
®
Page 3 of 3
locations.
Figure 5
Figure 7
packaging that your product came in.