Other Maintenance - Uline H - 8651 Manual Del Usuario

Follow these steps to store unit:
1. Unplug power cord and bundle loosely.
2. Lift unit with both hands, using hand holds.
CLEANING
Because large volumes of air pass through air purifier
each day, it needs regular cleaning.
1. Unplug unit before cleaning.
NOTE: Do not use gasoline, thinners, solvents or
other chemicals for cleaning.
2. Wipe down with a soft, damp cloth.
3. Dust or vacuum interior and along sides. It is
recommended to clean interior when filters are changed.
CLEANING THE DUST SENSOR
Clean dust sensor when replacing the carbon filters.
1. Unplug unit before cleaning.
2. Locate dust sensor access door on right side of unit.
3. Open dust sensor access door.
OPERATING ISSUE
Unit fails to power on.
PAGE 5 OF 18
STORAGE
MAINTENANCE
TROUBLESHOOTING
CAUSES
Unit is not plugged in.
Front panel may not be properly
installed.
Household circuit breaker / ground fault
interrupter has tripped or blown a fuse.
Unit is damaged or in need of repair.
3. Cover, or place back in carton, if available. This will
prevent unit from accumulating dust over time.
4. Store unit in a cool and dry location.
4. Gently wipe surface of dust sensor with a cotton
swab. (See Figure 9)
Figure 9
5. Once cleaned, close dust sensor access door.

OTHER MAINTENANCE

Motor is permanently lubricated so it needs no service.
No other serviceable parts, other than filters, are
contained within unit.
Plug power cord into electrical outlet.
Remove and reinstall the front panel to
ensure proper placement.
Refer to Filter Replacement on page 4.
Reset circuit breaker / ground fault
interrupter, or replace fuse.
For assistance, contact a licensed
electrician.
Cease usage and unplug.
Contact Uline Customer Service at
1-800-295-5510 for assistance.
RECOMMENDATIONS
0721 IH-8651