Operation - Inflating Tires - HDX HD-005 Guía De Uso Y Cuidado

Operation – Inflating Tires
1
Preparing the inflator Preparing the inflator
Preparing the inflator Preparing the inflator
Position the tire so that the valve is at the bottom, closest
□
to the ground, and place the inflator unit (A) next to the tire.
Remove the cord storage cover (L) to reveal the air hose (C)
□
and power cord (B).
Ensure that the compressor switch (G) is set to the OFF
□
position, and plug the power cord (B) into an appropriate
power source (DC 12V or a cigarette lighter socket).
L
G
B A
4
2
Operating the inflator Operating the inflator
Operating the inflator Operating the inflator
WARNING: Avoid over-inflating. Never exceed the
recommended pressure, as items over-inflated may burst
and cause serious injury.
IMPORTANT: When inflating tires, ensure that the
connector is screwed into the valve stem until it is firmly in
place.
Place the lock valve stem connector (D) onto the tire valve
□
stem, pushing down as far as possible, and close the thumb
latch.
Set the compressor switch (G) to the ON position, and
□
monitor the pressure gauge (J).
When the required pressure is reached, release the thumb
□
latch and remove the lock valve stem connector (D) from
the tire valve.
Set the compressor switch (G) to the OFF position, and
□
remove the power cord (B) from the power source.
Place the air hose (C) and power cord (B) back into the
□
storage area, and secure them with the cord storage cover
(L).
IMPORTANT: Always check items being inflated with a
proper pressure gauge.
D
J
G
B
L
A