Operation - Using The Light; Troubleshooting - HDX HD-005 Guía De Uso Y Cuidado

Operation – Using the Light
1
Choosing a function Choosing a function
Choosing a function Choosing a function
Plug the power cord (B) into an appropriate power source
□
(DC 12V or a cigarette lighter socket).
To use the light (I) as a flashlight, remove the red warning
□
light cover (K) and set the light switch (H) to the "I"
position.
To use the light (I) as a warning light (emergency mode),
□
ensure the red warning light cover (K) is attached and set
the light switch (H) to the "II" position.

Troubleshooting

Problem Problem
Problem Problem
The inflator does not start, or blows fuses when connected to a
power source.
The compressor runs but does not inflate.
The inflator runs slowly.
I
K
Solution Solution
Solution Solution
Push the power plug firmly into the cigarette lighter socket,
□
and twist it back and forth.
Check the cigarette lighter socket and plug terminals for dirt
□
– particularly tobacco ash. Use a non-conductive probe, not
fingers or metal.
Check the cigarette lighter fuse: It should be operational
□
and rated at 10 amps.
Ensure the lock valve stem connector is properly seated
□
onto the valve stem or adapter before closing the thumb
latch.
Check the inflator unit, air hose, and connections for leaks.
□
Unplug the power cord, and allow it to cool for 30 minutes
□
(it may be overheated from excessive use).
Ensure that the power source is supplying the proper
□
voltage (12V). If using the cigarette lighter adapter, check to
make sure that the vehicle battery is fully charged, or that
the vehicle is running.
6
B
H