Hydrofarm Sunburst SBD2540 Manual De Instrucciones página 2

SYSTEM INCLUDES:
• Sunburst E-Fixture 250/400W – (1)
• Reflector hanging hooks – (2)
• 8' grounded power cord – (1)
DESCRIPTION
Thank you for your purchase of a Sunburst All-In-One Lighting System. The Sunburst is an efficient
electronic ballast and reflector in one compact package. It delivers more usable light energy for
maximum plant performance and operate at cooler, quieter levels than any other compact system on
the market.
This Sunburst model accepts most High Pressure Sodium (HPS) and Metal Halide (MH) lamps, in 250
and 400 Watt models. The integrated ballast automatically senses which type of lamp it is running and
operates accordingly.
INSTALLATION
1. Carefully remove all of the components from the box and the protective cardboard to ensure that
your Hydrofarm Sunburst box includes all of the parts listed in the "SYSTEM INCLUDES" section.
2. Inspect the included components for any damage, missing parts, or other concerns. Contact your
local retailer in order to get a replacement or new part if required.
3. If there is a protective film on the reflector surfaces, be sure to remove it completely prior to
turning on the system.
4. To set the Sunburst to the proper wattage, use the small red jumper switch on the rear of the
fixture. This switch allows selection between 250W and 400W operation. Before powering on the
unit, be sure that the wattage switch is set to the wattage setting which matches the lamp you will
be using.
5. Screw your lamp securely into the socket (but do not overtighten). You can use nearly all HPS or
MH lamps of either 250W or 400W rating*. For MH, we recommend our Agrosun Gold Halide
(250W), Sunmaster MH (400W), or Digilux MH lamps (400W). For HPS lamps, we recommend our
Xtrasun HPS (250W and 400W available).
*BT37 type lamps will not fit in this fixture.
HANGING YOUR SUNBURST
1. Make sure your unit is unplugged.
2. Use the included V-hangers by placing the two hooked ends of the hanger into the two holes in
the top of the reflector housing (hook ends facing inward).
3. Hang the fixture from a strong cord or chain from both ends (we recommend our Light Riser
System, item code LULIFT, for hanging the Sunburst). If setting up in a room, make sure you have
hooks screwed solidly into the studs in the ceiling. If you cannot locate the studs, insert expansion
anchors (wall anchors) into the ceiling. The anchors, as well as the hooks used in them, should be
rated to hold at least 25 lbs each. If using a grow tent, you will need to hang the unit from a top
bar in the tent's framing.
4. Use a cable tie, twine, or similar method to secure the electrical cord to the hanging cord/chain so
that the cord's weight doesn't tilt the fixture.
SPECIAL NOTES, INSTRUCTIONS AND OPTIONS
• The Sunburst system fixture is intended for 120/240V 50/60 Hz
www.Hydrofarm.com
2
INSTRUCTIONS