allen+roth 35614BNRPL Manual De Instrucciones página 8

7.
Insert 1 in. tube plug (G) into 1 in. diameter
tube (B).
NOTE: Be sure to line up the indentations
in the 1 in. tube plug (G) with the holes in
the 1 in. diameter tube.
Repeat this step using the 7/8 in. tube
plug (F) and 7/8 in. diameter tube (A).
IMPORTANT: This step may be easier if
you insert a threaded sleeve (CC) through
the holes (only to be used as a guide)
before pushing the tube plug into place.
After inserting the tube plug, be sure to
remove the threaded sleeve (CC).
Hardware Used
Threaded Sleeve
CC
8. Insert plastic rings (AA) into the end of
the 1 in. diameter tubes (B). Then, insert
the 7/8 in. diameter tube (A) into the 1 in.
diameter tubes (B).
Extend the tubes to the proper length to
fit between the 1 in. mounting bracket (E)
and 7/8 in. mounting bracket (D).
Hardware Used
Plastic Ring
AA
IS35691-I2
7
x 2
8
B
x 2
8
G
AA
CC
B
A