allen+roth 35614BNRPL Manual De Instrucciones página 9

9. Fasten the 1 in. diameter tube (B) to the 1
in. mounting bracket (E) using threaded
sleeves (CC) and end cap screws (BB).
Secure with large Allen wrench (FF).
Repeat this step for the 7/8 in. diameter
tube (A).
NOTE: To level the rod assembly, tighten
the preassembled set screws on the
mounting brackets with medium Allen
wrench (GG).
Hardware Used
Threaded Sleeve
CC
End Cap Screw
BB
10. Attach end caps (C) to 1 in. mounting
bracket (E) and 7/8 in. mounting bracket
(D) using set screws (II) at the top and
bottom. Adjust set screws (II) with small
Allen wrench (HH) as needed.
Hardware Used
Small Allen Wrench
HH
Set Screw
II
IS35691-I2
9
B
x 1
Medium Allen Wrench
GG
Large Allen Wrench
FF
x 1
10
x 1
x 4
9
E
BB
II
II
CC
x 1
x 2
C