X-LITE X-661 Seguridad E Instrucciones página 16

4.7. Remove the protective film from the PINLOCK
entire silicone-sealed profile of the inner visor adheres to the visor.
4.8. Fit the visor on the helmet (see instructions above).
Checking and Adjusting the PINLOCK
Check the correct PINLOCK
and making sure that they do not move.
If the PINLOCK ® inner visor is not tightly fixed to the visor, move both external adju-
stment levers upwards to increase the stretch (Fig. 5). This operation must be carried
out gradually. The maximum stretch is achieved when the pin adjustment external
levers are turned outwards
WARNING
- The presence of dust between the two visors may produce scratches on both
surfaces.
- Scratched PINLOCK
must therefore be replaced.
- Regularly check the correct stretch of the PINLOCK
it from moving and scratching both surfaces.
- If the helmet visor fogs up and/or condensation forms between the visors,
check that the PINLOCK
ched.
- An excessive and early stretch of the PINLOCK
excessive adherence against the visor surface and/or permanent deformations
with subsequent inability to correctly perform any following adjustments.
- Intense sweating /breathing, the use under particular weather conditions (low
temperatures, and/or high humidity and/or sudden changes in temperature
and/or heavy rain) and/or intense and prolonged use may affect the performan-
ce of the PINLOCK
tion. In such cases, after using the helmet and to restore the system efficien-
cy, remove the PINLOCK
dry and warm air. The same procedure must be applied to the helmet, in order
to dry out humidity in case it has formed up as a consequence of the condi-
tions described above.
5. Inner Visor PINLOCK
5.1. Remove the visor equipped with the Pinlock
above).
5.2. Widen the visor and release the Pinlock
5.3. Release the visor.
Maintenance and Cleaning
- Remove the PINLOCK
gently clean it with neutral liquid soap. Remove the soap under running water.
- Dry the inner visor with dry and warm air without wiping it.
- To keep the features of the inner visor in good conditions over time, let the hel-
met dry in a ventilated and dry place with the visor open after use. Keep it
® Inner Visor Stretch
® inner visor assembly by opening and closing the visor
® visors and inner visors may cause reduced visibility and
® inner visor is both correctly assembled and stret-
® inner visor and cause fogging or formation of condensa-
® inner visor from the helmet visor and let it dry with
® Disassembly
® inner visor from the visor. Using a damp and soft cloth,
16
® inner visor and check that the
® inner visor to prevent the
® inner visor may result in
® inner visor (see instructions
® inner visor from the pins (Fig. 7).