Echo 21560065B Manual De Instrucciones página 2

nylon line replacement
1. Shut engine off, and disconnect spark plug wire. Lay unit on ground with trimmer head assembly up.
2. Hold drum (A) firmly, and turn knob (B) clockwise. Remove knob and spring (C).
3. Pull spool (D) from drum (A), and pull drum (A) off mounting shaft.
4. Use one piece of new nylon line (E) and thread through the molded loop (F) on the spool. Pull line tight and adjust so one end is
15 cm (6 in.) longer than the other.
5. Hold the spool, pegs toward you. Place index finger between the two strands, and wind line tightly and evenly in the direction of
arrow. Avoid twisting lines.
6. Place ends of lines into notches (G) in spool (D), leaving 6 in. protruding.
7. Place spool (D) over drum (A), Feed ends of line outward through eyelets (H) in drum.
8. Hold spool and drum securely with one hand, and pull each line to disengage from notches.
9. Slide drum and spool onto mounting shaft.
10. Place spring (C) over mounting shaft, and secure spool with knob (B). Turn knob counterclockwise to tighten.
11. Trim lines to 8 in. length.
2