Jøtul 51043381 Instrucciones Para Instalación página 12

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 15
ENGLISH
Installing the grid
(Fig. 10)
Use the 4 heat shield screws to attach the grid retainers to the
sides of the insert in the same holes as the ones where the
heat shields are attached. NB: If you remove a heat shield, see
pt. 3 "Preparation/installation" in this manual.
The side grid is hooked onto the grid retainers by moving the
two pins down through the holes in the tops and bottoms of
the grid retainers (Fig. 10).
Where necessary, rotate the side grid into the correct position
and move the lock down to the hearth floor. This is done from
the outside of the grids using a screwdriver. (Fig. 16)
Use a pencil to mark where the lock meets the hearth floor.
Turn the side grids back slightly.
Drill a 10 mm deep hole (Ø8-10mm) at the pencil mark.
Move the side grids back into the correct position and move
the grid lock down into the hole (Fig. 16).
Screw the bottom grid into position using 2 tapping screws
4.8x19mm (Fig. 12).
Screw the top grid into position using 2 tapping screws 4.8x19mm
(Fig. 15).
12

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

510121575101215851012159361153341273341275 ... Mostrar todo

Tabla de contenido