Maintenance And Cleaning - Nolan N87 plus Seguridad E Instrucciones

If the PINLOCK
®
ment levers upwards to increase the stretch (Fig.4). This operation must be carried
out gradually. The maximum stretch is achieved when the pin adjustment external
levers are turned outwards.
WARNING
- The presence of dust between the two visors may produce scratches on both
surfaces.
- Scratched PINLOCK
must therefore be replaced.
- Regularly check the correct stretch of the PINLOCK
moving and scratching both surfaces.
- If the helmet visor fogs up and/or condensation forms between the visors, check
that the PINLOCK
- An excessive and early stretch of the PINLOCK
sive adherence against the visor surface and/or permanent deformations with
subsequent inability to correctly perform any following adjustments.
- Intense sweating/breathing, the use under particular weather conditions (low
temperatures, and/or high humidity and/or sudden changes in temperature and/
or heavy rain) and/or intense and prolonged use may affect the performance of
the PINLOCK
such cases, after using the helmet and to restore the system efficiency, remove
the PINLOCK
air. The same procedure must be applied to the helmet, in order to dry out humid-
ity in case it has formed up as a consequence of the conditions described above.
4 Inner visor PINLOCK
4.1 Remove the visor equipped with the Pinlock
4.2 Widen the visor and release the Pinlock
4.3 Release the visor.

Maintenance and cleaning

- Remove the PINLOCK
gently clean it with neutral liquid soap. Remove the soap under running water.
- Dry the inner visor with dry and warm air without wiping it.
- To keep the features of the inner visor in good conditions over time, let the helmet
dry in a ventilated and dry place with the visor open after use. Keep it away from
heat sources and store it in a place away from direct light.
- Do not use solvents or chemical products.
VISION PROTECTION SYSTEM (VPS)
The exclusive inner VISION PROTECTION SYSTEM (VPS) is a LEXAN™(*) polycar-
bonate moulded sunscreen with scratch-resistant/fog-resistant treatment. Very sim-
ple and practical to use. Just lower to activate it or lift to remove it from the field of
vision. It is useful in all sorts of situations, both on long journeys out of town and
shorter town trips.
Moreover, the innovative fastening system allows you to assemble and disassemble
the sunscreen without the need for any tools for ordinary maintenance and cleaning
operations.
LEXAN is a trademark of SABIC.
(*)
inner visor is not tightly fixed to the visor, move both external adjust-
visors and inner visors may cause reduced visibility and
®
inner visor is both correctly assembled and stretched.
®
inner visor and cause fogging or formation of condensation. In
®
inner visor from the helmet visor and let it dry with dry and warm
®
disassembly
®
inner visor from the visor. Using a damp and soft cloth,
®
inner visor to prevent it from
®
inner visor may result in exces-
®
inner visor (see instructions above).
®
inner visor from the pins (Fig.6).
®
17