Maintenance And Cleaning - Nolan N60-6 Instrucciones

2 CHECKING AND ADJUSTING THE STRETCH
Check that the PINLOCK
the visor and ensuring that they do not move with respect to each other.
Should the PINLOCK
gradually and not excessively, both external adjustment levers upwards, to increase
the stretch (Fig.3). The maximum stretch is achieved when the pin adjustment external
levers are positioned outwards.
WARNING
- Dust between the two visors may cause both surfaces to scratch.
- Scratched PINLOCK
must therefore be replaced.
- Regularly check the correct stretch of the PINLOCK
moving and scratching both surfaces.
- If, in use, the helmet visor fogs up and/or condensation forms between the visors,
check that the PINLOCK
- An excessive and early stretch of the PINLOCK
sive adherence against the visor surface and/or permanent deformations with
subsequent inability to correctly perform future adjustments.
- Intense sweating/breathing, use in particular weather conditions (low tempera-
tures, high humidity, sudden changes in temperature or heavy rain) and/or intense
and prolonged use may affect the performance of the PINLOCK
ing fogging or formation of condensation. In such cases, to restore the system ef-
ficiency after using the helmet, remove the PINLOCK
visor and leave it to dry in warm and dry air. The same procedure must be applied
to the helmet, which should be left to dry to remove any humidity that may have
formed as a result of the conditions described above.
3 DISASSEMBLY
3.1 Disassemble the visor equipped with the PINLOCK
above).
3.2 Widen the visor and release the PINLOCK
3.3 Release the visor.
4

MAINTENANCE AND CLEANING

- Remove the PINLOCK
gently clean it with mild liquid soap. Rinse off all the soap under running water.
- Leave the visor to dry in warm and dry air without wiping it.
- To preserve the visor's condition over time, leave the helmet to dry in a ventilated
and dry place with the visor open after use. Keep it away from heat sources and
store it in a place away from direct light.
- Do not use solvents or chemical products.
VISION PROTECTION SYSTEM ( VPS ) - ( VPS-15 )
The exclusive inner VISION PROTECTION SYSTEM (VPS) is a LEXAN™ (*) polycar-
bonate moulded sunscreen with scratch-resistant/fog-resistant treatment. It is very
simple and practical to use: just lower it to activate it or lift it to remove it from your field
LEXAN is a trademark of SABIC.
(*)
inner visor has been correctly fitted by opening and closing
®
inner visor not be tightly fixed to the visor, simultaneously move,
®
visors and inner visors may cause reduced visibility and
®
inner visor is both correctly fitted and stretched.
®
inner visor from the visor. Using a damp and soft cloth,
®
inner visor to prevent it from
®
inner visor may result in exces-
®
inner visor from the helmet
®
inner visor (see instructions
®
inner visor from the pins (Fig.5).
®
INSTRUCTIONS FOR USE
N60-6
inner visor, caus-
®
15