Maintenance And Cleaning - Nolan N60-5 Seguridad E Instrucciones

2 CHECKING AND ADJUSTING THE PINLOCK
Check the correct PINLOCK
and make sure that they do not move.
If the PINLOCK inner visor is not tightly fixed to the visor, move gradually both external
®
adjust-ment levers upwards to stretch (Fig.3).
The maximum stretch is achieved when the pin adjustment external levers are turned
outwards.
WARNING
- The presence of dust between the two visors may scratch both surfaces.
- Scratched PINLOCK
therefore be replaced.
- Regularly check the correct stretch of the PINLOCK
moving and scratching both surfaces.
- If the helmet visor fogs up and/or condensation forms between the visors, check
that the PINLOCK
- An excessive and early stretch of the PINLOCK
sive adherence against the visor surface and/or permanent deformations with
subsequent inability to correctly perform any following adjustments.
- Intense sweating/breathing, the use under particular weather conditions - low
temperatures, high humidity, sudden changes in temperature, heavy rain - or wear
may affect the performance of the PINLOCK
condensation. In such cases, remove the PINLOCK
visor and let it dry with dry and warm air after use, to restore its performance. The
same procedure should be applied to the helmet in order to dry out humidity in
case it has formed up as a consequence of the conditions described above.
3 PINLOCK INNER VISOR DISASSEMBLY
®
3.1 Remove the visor with PINLOCK
3.2 Widen the visor and release the PINLOCK
3.3 Release the visor.
4

MAINTENANCE AND CLEANING

- Remove the PINLOCK
gently clean it with neutral liquid soap. Remove the soap under running water.
- Dry the inner visor with dry and warm air without wiping it.
- Let the helmet dry in a ventilated and dry place with the visor open after use. Keep
it away from heat sources and store it in a place away from direct light. This way
inner visor will be kept in good conditions over time.
- Do not use solvents nor chemicals.
REMOVABLE INNER COMFORT PADDING
1 CHEEK PAD DISASSEMBLY
1.1 Unfasten the chin strap (see relevant instructions).
1.2 Pull the front part of the left cheek padding towards the inside of the helmet to
release the three snap fasteners placed on the back (Fig.6).
inner visor assembly by opening and closing the visor
®
visors and inner visors may reduce visibility and should
®
inner visor is both correctly assembled and stretched.
®
inner visor as per instructions above.
®
inner visor from the visor. Using a damp and soft cloth,
®
INNER VISOR STRETCH
®
inner visor to prevent it from
®
inner visor may result in exces-
®
inner visor and cause fogging or
®
inner visor from the helmet
®
inner visor from its pins (Fig.5).
®
INSTRUCTIONS FOR USE
N60-5
13