jbc PHB-A Manual De Instrucciones página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Safety
It is imperative to follow safety guidelines to protect health and prevent electric
shock, injury, fire or explosions.
- Do not use the units for any purpose other than PCb preheating. Incorrect use may cause fire.
- The mains cable must be plugged into approved bases. be sure that it is properly grounded
before use.
- The temperature of accessible surfaces may remain high after the unit is turned off. Handle with care.
- Do not leave the appliance unattended when it is on.
- Do not cover the ventilation grills.
- Heat can cause inflamable products to ignite even when out of sight.
- be careful with the remains of liquid tin. In contact with skin, it can cause burns.
- Use a "non residue" classified flux and avoid contact with skin or eyes to prevent irritation.
- be careful with the smoke produced when soldering.
- Keep your workplace clean and tidy. Wear appropriate protection glasses and gloves when
working to avoid personal harm.
- This appliance can be used by children over the age of eight and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge once they have
been given adequate supervision or instruction concerning use of the appliance and understand
the hazards involved. Children must not play with the appliance. Maintenance shall not be
carried out by children unless supervised.
- Maintenance of the units must be carried out by an authorized after-sales service.
8
Specifications
Convection Preheater
PHB-1A 120V. Input 120V 50/60Hz Fuse 15a
PHB-2A 230V. Input 230V 50/60Hz Fuse 10a
PHB-9A 100V. Input 100V 50/60Hz Fuse 15a
- Weight: 7 kg (15.4 lb)
- Dimensions (Heater Unit): 426 x 446 x 41 mm
- Maximum Power: 1800W / 1800W / 1400W
- Heating area: 180 x 277 mm (1 zone) 360 x 277 mm (2 zones)
- Temperature Range: 50-250°C (120-482ºF)
- Temperature Measurement: Thermocouple type K
- JbCset temperature profiles: 3 profiles ( 2, 3 or 4 steps)
- User Profiles: 20 (up to 6 steps for each)
- Maximum work time: 600 min or indefinite
Complies with CE standards
ESD protected housing "skin effect"
w w w.jbctools.com
9

Publicidad

Tabla de contenido
loading

Tabla de contenido