Smartphone App; Cleaning And Maintenance; Technical Specifications - cecotec READY WARM 800 THERMAL CONNECTED Manual De Instrucciones

ENGLISH
Mode
Standby mode
Heating mode
Fig. 13.
Temperature
Fig. 14.
Press the temperature button to set the desired temperature. Temperature can be set from 5
ºC to 40 ºC.
Internal temperature is displayed every time the appliance is started up.
The temperature can be set when the appliance is in standby or heating mode.
When the room temperature reaches the set temperature, the high temperature power stops,
and the low temperature power remains active.
When room temperature is 2 degrees over the set temperature, both the high and lower
temperature powers will stop operating. The machine will begin operating again only when
temperature decreases 2 degrees with respect to the set temperature.
Timer
Fig. 15.
The timer button can be set to start or stop the appliance at the desired time, with a time
interval between 1 hour and 24 hours.
Remote control
Fig. 16.
The touch screen buttons located on the product correspond to the remote control functions:
1. On/off button
2. Mode
3. Temperature
4. Timer
5. Child lock system
Child lock system
Press and hold the child lock button on the remote control for 3 seconds to activate the child
lock safety system.
Press and hold the child lock button on the remote control for 3 seconds to deactivate the
child lock safety system.
Note: To activate or deactivate this function from the control panel, hold down the heat
button for 3 seconds.
32 READY WARM 800/1200/1800/2000/2500 THERMAL CONNECTED

5. SMARTPHONE APP

In order to link your product with our app, please follow the following steps:
Download EnergySilence app from Google Play or App Store.
If it is the first time you are using this App, register an account. If not, log in.
Once you enter the App, press "+" on the top right corner and press "ReadyWarm Thermal".
Turn the device on, check that the Wi-Fi indicator on the display blinks. If it does not blink,
press the temperature button until it beeps and the indicator starts blinking quickly.
Enter your Wi-Fi password and press confirm. Remember the Wi-Fi network must be 2.4 GHz.
Then, the linking process will start automatically. In case there is an error during the linking
process, press the temperature button again until the Wi-Fi light indicator blinks slowly.
Confirm that the Wi-Fi network and the password are correct, and then follow the indications
on the App.
Go to your smartphone's Wi-Fi networks, select your device's Wi-Fi network and return to the
App to complete the linking process.

6. CLEANING AND MAINTENANCE

Turn off, unplug the appliance from the power supply and allow it to cool down before
cleaning or repairing it.
Use a soft, dry cloth to clean the product's outside parts.
Do not use chemical or abrasive cleaning agents or scouring pads, as these may damage the
product's surface.
Clean dust and dirt from the surface regularly.
Do not immerse the device in water and do not wet it at all.
If the device is not going to be used in a long time, clean it and store it in a well-ventilates,
safe place out of the reach of children.

7. TECHNICAL SPECIFICATIONS

Product: Ready Warm 800 Thermal Connected
Reference: 05372
600 W, 220-240 V, 50/60 Hz
Product: Ready Warm 1200 Thermal Connected
Reference: 05373
900 W, 220-240 V, 50/60 Hz
READY WARM 800/1200/1800/2000/2500 THERMAL CONNECTED
ENGLISH
33