Telstar TVW018110MD Manual De Instrucciones página 7

PART FIGURE
Front grill
GRILL & FAN BLADE ASSEMBLY
1. Unscrew the spinner clockwise (or take the spinner out from the bag) and the plastic nut counterclockwise
to remove both of them. Fix the rear grill to the motor then tighten the plastic nut again. (Fig. 1)
2. Insert the blade into shaft, and make sure the rotor shaft pin is fitted into groove of the blade. Turn the
spinner counterclockwise to tighten the blade. (Fig. 2)
3. Fasten the front grill and the rear grill by the grill clip and then tighten the fan grill locking screw and nut.
(Fig. 3)
Fig.1
OPERATING INSTRUCTION
The fan should be installed on a solid wooden or pillar which stands vertically to the floor.
Caution:
To prevent the fan from falling off, do not install it on walls less then 10 cm thick or made of materials
that are easily damaged.
Circlip Blade
Plastic
Spinner
nut
Fig.2F
7
Rear grill
Motor shaft
Motor
ig.3
WALL FAN
TVW018110MD