Speed Adjustment - Telstar TVW018110MD Manual De Instrucciones

Installing the mounting bracket
Fix the supplied mounting bracket firmly to the wall using the three screws.
NOTE :
The bracket should be positioned at least 35 cm from the ceiling and at
least 30 cm from adjoining wall.
Installing the stand
Mount the stand on the bracket by inserting the bracket catch into the slot on the
stand.
Fix the stand onto the bracket with a retaining nut.
NOTE :
If the retaining nut does not pass through the holes, push the stand
downwards until it is fully mounted on the bracket.

SPEED ADJUSTMENT

Adjust to the desired speed by pulling the switch cord (A).
0---Off 1---Low 2---Medium 3---High
OSCILLATION CONTROL
Pull switch cord (B) to start and stop fan oscillation.
TO ADJUST THE WIND DIRECTION
Push the guard lightly to the desired up or down direction
MAINTENANCE INSTRUCTION
The fan requires little maintenance. Do not try to fix it by yourself. Refer it to qualified service personnel if service
is needed.
1. Before cleaning and assembling, fan must be unplugged.
2. To ensure adequate air circulation to the motor, keep vents at the rear of the motor free of dust. Do not
disassemble the fan to remove dust.
8
WALL FAN
TVW018110MD