Setting Language For Lcd Display; Operating Instructions; Spot Welding - DENTAURUM Master 3000 Manual Del Usuario

5.1 Setting language of LCD display
The Master 3000 is able to display five different languages on the LCD display. These languages are:
• German (manufacturer's setting)
• French
• Spanish
1. To select one of these languages, the unit must be turned off at the power switch .
2. Press pad  and  and turn the unit on at the power switch  at the same time.
3. The LCD display now shows a language selection e. g. German and English
4. With the pad  or  the lines can be moved up or down to select other languages.
The language appearing in the top line can be selected. The cursor flashes in this line.
5. Press printer pad  to select the language in the top line.

6. Operating instructions

6.1

Spot welding

!!
Always wear goggles for welding work.
!
When using the hand electrodes for welding, the electrodes must not touch each
other at the electrode holders, otherwise electric current will flow through the
electrode holders and the hand electrodes, and cause poor welding results.
I n order to meet the complex requirements for constructing orthodontic appliances, the Master 3000 is
fitted with six different copper electrodes for welding. These have special contact tips or surfaces.
The "click-stop" electrode holders ,  permit quick and easy changing from one electrode to the
other. When the holder is turned to the desired position, the electrodes click into the correct position
with reference to one another.
Maximum load on unit
If the unit is being used over several hours, only one welding pulse at the most should be activated
every 5 seconds.
However, if it is only being used for a few minutes (max. 30 minutes) a pulse can be activated every second.
• English
• Italian
EN EN
master 3000  en
35