Using The Inverter; Operating Steps; Technical Specifications - nuair Avanty Manual Del Usuario

GB

USING THE INVERTER

The inverter output voltage is 230V / 50Hz, power to 300W.
This unit has low-voltage protection function. To protect
the battery from damage, when the voltage falls below a
certain value, it will alarm, then turn off automatically.
There is also a protection against short circuits or overloads,
e.g. if the external power supply equipment causes a short
circuit, the Power Station turns automatically off.

Operating steps:

1) Set the inverter switch (15) in ON position.
2) Plug the electric equipment into the socket (10).
Beware to its power should not exceed 300 W.
3) Start electrical equipment.
4) Check the battery capacity by means of the test button
or watching the status of the power indicator lights
(14).
5) Turn off the electrical equipment after switching off the
inverter (15).
6) When the inverter fails, the inverter status light (16) is
lit. Please check the condition of the electrical appliance
and the battery status (by means of the battery status
test button).
7) When the power of the electrical device (to be powered)
is too much high, or an external short-circuit occurs,
it might damage the fuse (17), located on the device.
Replace with an identical fuse (30A).
MAINTENANCE
● Always inspect the power station before use to ensure
the cables are in perfect condition and the clamps are
clean and free from corrosion.
● Keep the unit clean by wiping with a dry cloth. DO NOT
use solvents as a cleaning agent.
● Keep the unit at HIGH or FULL CHARGE status at all
times.

TECHNICAL SPECIFICATIONS:

Functions: − Portable & Rechargeable Power
− Inverter 230 V
− 400 A Cranking Power Jump-Starter
− Heavy duty cables & clamps
− 18 bar (max) air compressor
− Tire pressure gauge
− 2 DC outlets 12 V
− 2 USB port 5 V
− 7 LEDs torchlight
− Storage Compartment
Battery: − High grade Sealed Lead Acid
(Maintenance Free)
− 20 Ah
Outputs: − 230-240 V
− 2 x 12 V
− 2 x 5 V
Safety features: − Reverse Protection and Alarm
− Overload Protection (car-type fuse)
− Short Circuit Protection
− Discharge Protection (alarm)
− LED indicator lights for the 12V /
20Ah battery charge
− Voltmeter battery power test button
Included − Michelin-type inflation hose
accessories: − LEDs torchlight
− Set of 3 inflation nozzles
− 230 V
− 12 V
car dashboard lighter socket
Unit dimensions: 330 x 250 x 270 mm
Weight: 11 kg
It is recommended to fully charge your Power
Station (24-36 hours), before the first use, after
each use and every 3 months.
14
(300 W maximum)
AC
50 Hz
AC
(cigarette lighter socket)
DC
(USB)
DC
/ 500 mA charger
AC
adapter for recharging by
DC