Troubleshooting - Freeman PE20V1GCK Manual De Instrucciones

MODEL: PL31

TROUBLESHOOTING

! WARNING:
Stop using tool immediately if any of the following problems occur. Serious personal
injury could result. Any repairs or replacements must be done by a qualified service
person or an authorized service center.
PROBLEMS POSSIBLE CAUSE(S)
Air leaking at trigger O-rings in trigger valve housing are
valve area. damaged.
Air leaking between 1.Loose screws in housing.
housing and nose. 2.Damaged O-rings.
3.Damaged to bumper.
Air leaking between 1.Loose screws.
housing and cap. 2.Damaged gasket.
1.Worn bumper.
Tool skips driving
2.Dirt in nose piece.
fastener.
3.Dirt or damage prevent fasteners or
pusher from moving freely in magazine.
4.Damaged pusher spring.
5.Inadequate air flow to tool.
6.Worn O-ring on piston or lack
of lubrication.
7.Damaged O-ring on trigger valve.
8.Air leaks.
9.Cap seal leaking.
Tool runs slow or has 1.Tool not lubricated sufficiently.
loss of power. 2.Broken spring in cylinder cap.
3.Exhaust port in cap is blocked.
Fasteners are jammed 1.Guide on drive blade is worn.
in tool. 2.Fasteners are not correct size.
3.Fasteners are bent.
4.Magazine or nose screws are loose.
5.Drive blade is damaged.
!
WARNING:
Only use Freeman authorized repair parts. For questions please call 1-888-669-5672 or
visit our website at http://www.freemantools.com.
WEARABLE PARTS
Repair parts can be ordered from our website: http://www.freemantools.com.
12
HTTP://WWW.FREEMANTOOLS.COM
CORRECTIVE ACTION
Replace O-rings. Check operation
of Work Contact Element(WCE).
1.Tighten screws.
2.Replace O-rings.
3.Replace bumper.
1.Tighten screws.
2.Replace gasket.
1.Replace bumper.
2.Clean drive channel.
3.Clean magazine.
4.Replace spring.
5.Check fitting, hose, or compressor.
6.Replace and lubricate O-rings.
7.Replace O-rings.
8.Tighten screws and fittings.
9.Replace gasket.
1.Lubricate nailer.
2.Replace spring.
3.Replace damaged internal parts.
1.Replace guide.
2.Use only recommended fasteners.
3.Replace with undamaged fasteners.
4.Tighten screws.
5.Replace drive blade.
1-888-669-5672
MODEL: PL31
PGP INC. PRODUCT WARRANTIES
FREEMAN Pneumatic Nail Guns Warranties
2 Year Professional Tool Warranty
The Freeman Tool limited warranty extends exclusively to the original purchaser of the Freeman
Product, begins on the date of purchase and excludes wearable parts. During the warranty period
Prime Global Products, Inc. (PGP) expressly warrants that the Freeman Product is free from defect
in materials and workmanship subject to the exceptions and limitations contained herein. PGP shall
at its option, repair, replace, or offer a full refund for a Freeman Product that has a defect in
materials or workmanship.
90 Day Wearable Parts Warranty
The Freeman wearable parts limited warranty extends exclusively to the original purchaser of the
Freeman Product and begins on the date of purchase, and includes driver blades, bumpers, O-
rings, pistons, piston rings, and gaskets. During the warranty period PGP expressly warrants that
the Freeman Product is free from defect in materials and workmanship subject to the exceptions
and limitations contained herein. PGP shall at its option, repair, replace, or offer a full refund for a
Freeman Product that has a defect in materials or workmanship.
A DATED SALES RECEIPT OR PROOF OF PURCHASE FROM THE ORIGINAL RETAIL PURCHASER
IS REQUIRED TO MAKE A WARRANTY CLAIM. Warranty registration is also required and can be
accomplished through On-Line Product Registration at www freemantools com, select SUPPORT,
select PRODUCT REGISTRATION. To make a warranty claim, the original purchaser must return the
Freeman Nail Gun, postage prepaid and insured, with proof of purchase to PGP or any of its
authorized service centers. For questions please call 1-888-669-5672. Other than the postage and
insurance requirement, no charge will be made for repairs covered by this warranty.
Warranty Exclusions
These Warranties do not apply where:
Repairs or alterations have been made, or attempted, by others, and/or the unauthorized use of
non-conforming parts or accessories.
Repairs are required due to normal wear and tear.
The Nail Gun has been abused, misused, improperly maintained or operated, including: the
failure to use clean, dry, regulated compressed air at the recommended pressure; accidents
caused by use of the Freeman Product after partial failure.
The Freeman Product is used commercially in assembly lines or production lines. The
Product is intended for use by individuals and these warranties do not extend to such
commercial uses.
NO WARRANTY, ORAL OR WRITTEN, EXPRESSED OR IMPLIED, OTHER THAN THE ABOVE
WARRANTIES IS MADE WITH REGARD TO THIS FREEMAN PRODUCT. ANY IMPLIED
WARRANTIES WILL BE LIMITED IN DURATION TO THE APPLICABLE WARRANTY PERIOD
SPECIFIED ABOVE. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED
WARRANTY LASTS, SO THE ABOVE MAY NOT APPLY TO YOU. YOUR REMEDIES ARE SOLELY
AND EXCLUSIVELY AS STATED ABOVE. PGP SHALL IN NO EVENT BE LIABLE FOR
INCIDENTAL, CONSEQUENTIAL, INDIRECT, OR SPECIAL DAMAGES. SOME STATES DO NOT
ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES,
SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. IN NO EVENT,
WHETHER AS A RESULT OF A BREACH OF CONTRACT, WARRANTY, TORT (INCLUDING
NEGLIGENCE) OR OTHERWISE, SHALL PGP'S LIABILITY EXCEED THE PRICE OF THE
PRODUCT WHICH HAS GIVEN RISE TO THE CLAIM OR LIABILITY. ANY LIABILITY CONNECTED
WITH THE USE OF THIS PRODUCT SHALL TERMINATE UPON THE EXIRATION OF THE
WARRANTY PERIOD SPECIFIED ABOVE. NO EMPLOYEE OR REPRESENTATION OF PGP, OR
ANY DISTRIBUTOR OR DEALER IS AUTHORIZED TO MAKE ANY CHANGE OR MODIFICATION
OF THIS WARRANTY.
These warranties give you specific legal rights. you may also have other rights which vary from
state to state.
THESE WARRANTIES ARE SUBJECT TO CHANGE WITHOUT NOTICE.
HTTP://WWW.FREEMANTOOLS.COM
. .
Freeman
13
1-888-669-5672