Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
FEATURES
KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
2
1
3
8
9
7
4
5
6
1. HANDLE.
2. FUEL CAP.
3. FUEL TANK.
4. RECOIL STARTER.
5. ENGINE ON / OFF SWITCH.
6. CHOKE LEVER.
7. AIR FILTER HOUSING.
8. AC SOCKET.
9. RESET BUTTON.
10. EXHAUST.
11. ENGINE.
12. DC SOCKET.
TECHNICAL DATA
GG307
MAX. OUTPUT POWER
RATED OUTPUT POWER
PHASES
FREQUENCY
RATED AC VOLTAGE
RATED DC VOLTAGE
DISPLACEMENT
APPROXIMATELY RUN @ 50%
GASOLINE TANK CAPACITY
WEIGHT
OPERATION INSTRUCTIONS
LOCATION & GROUNDING
Before using this generator it must be prepared
correctly before use. Locate the generator on
firm level ground away from buildings or other
structures ensuring that the exhaust is not ob-
structed.
WARNING: It is advisable to properly earth-
ground your generator before starting using a
wire and a small earth stake.
NOTE: The wire and earth stake are not supplied
with the unit.
10
10
12
11
700 W
600 W
1~
60 Hz
120 V ~
12 V
63 cc
9 h
4 L (1,05 gal)
17 kg (37,4 lb)
Earth spike and cable can be purchased at your
local camping supplies, or alternatively an earth
spike can be made, and it is suggested you get
advice from a registered electrical trades per-
son. To make a spike use a copper tube or cop-
per rod 12 mm diameter, a minimum length
of 200 mm and with an M6 machine screw at
one end. The cable used should be a maximum
length of 1 meter and a minimum of 1,0 mm
carry a 10 A load.
The cable should be at-
tached to the generator
at the earth point (Fig.1)
and to the spike between
a flat washer and the cop-
per with a lock washer
under the head of the M6
machine screw in a similar
fashion to the earth point
screw on the generator.
When placing the Spike into the ground the gen-
erator must not be running and it is suggested
that the spike is pushed into the ground by at
least 100 mm so that it is firm and a liter of water
poured around it to ensure good earth continuity.
FUELING
This engine is designed to work with a mixture
of gasoline and oil, is recommended to use syn-
thetic 2-cycle engine oil.
If you use synthetic 2-stroke oil the mixture must
be 50: 1. If you use mineral oil 2-stroke the mix-
ture must be 25: 1.
EXAMPLE:
· To know the oil that you have to add to the
mixture, divide the amount of gasoline in the
proportion of oil required:
· To make a mixture of 4 liters of gasoline just
need to divide 4/50 (synthetic oil) resulting in
0.08 liters (80 milliliters) if instead used mineral
oil the formula would be 4/25 = 0.16 liters (160
milliliters)
FUEL MIXING
The fuel tank has a maximum capacity of 4L. To
mix the fuel correctly use the filler cap gauge
to measure the correct amount of oil to petrol.
WARNING: Do not mix
the fuel in the generator fuel
tank use a suitable container.
Measure the fuel into the
container then add the cor-
rect proportion of two stroke
oil according to the chart
shown in figure 2. When the
correct ratio has been mixed
2
to
Fig.1
Publicidad
Tabla de contenido
