Descargar Imprimir esta página

Beta 1462 KD Instrucciones página 8

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
INSTRUCTIONS FOR USE
ISTRUZIONI PER L'USO
The kit 1472KD, suitable for the extraction of injectors of DENSO brand, is formed by:
Five different types of tools (modular) to be fixed to the injector to be extracted.
Note: For the correct assembly of components refer to the drawings in this manual
and to the letters marked on the pieces.
Group for the extraction of the injectors with the aid of the impact mass.
PROCEDURE
Identify, among the five in the kit, the correct tool for the extraction of the injector using
the table and the assembly drawings in this manual.
Before using the tool
Before using the tool
If the tool is used
- Fasten the appropriate tool for the extraction using the thread(s) located at the
side of the central body of the injector.
- For this operation, use the screw M8 and the nut M12x1.5 included in the kit.
• If the tool is used
- Screw the lateral plate B to the central body and fix them
to the injector to be extracted (fig. 5).
- Screw the lateral plate A (fig. 6) and fasten the tool to the injector
using the nut M14x1.5 included in the kit.
If the tool is used
- Keep loosen the four screws that fasten the lateral plates C and D
to the central body and insert the tool on the injector to
be extracted (Fig. 7)
- Tighten the four screws fastening the two lateral plates (Fig. 8) and fasten the tool
to the injector using the nut M12x1.5 included in the kit.
Once fastened the tool on the injector, tighten the pin with the impact mass to the dowel M10
and proceed with the injector extraction operating manually with impact mass (fig. 9).
9
8
4
unscrew the screw between the motor rocker arms (Fig. 1).
5
remove the U bolt /rocker arm (fig. 2-3-4).
1
2
3
,
or
4
5
8
7
EN
I
1
2
3
4
5
6

Publicidad

loading