Battery Charger Safety - Beta 1498-16A Instrucciones

INSTRUCTIONS FOR USE
ELECTRONIC BATTERY CHARGER, 12-24V 16A
OPERATING MANUAL AND INSTRUCTIONS FOR ELECTRONIC 12-24V 16A BATTERY CHARGER MANUFACTURED BY:
BETA UTENSILI S.P.A.
Via A. Volta 18,
20845, Sovico (MB)
ITALY
Original documentation drawn up in ITALIAN.
CAUTION
IMPORTANT! READ THIS MANUAL CAREFULLY BEFORE USING THE BATTERY CHARGER. FAILURE TO
COMPLY WITH THE SAFETY STANDARDS AND OPERATING INSTRUCTIONS MAY RESULT IN SERIOUS
INJURY.
Store the safety instructions with care and hand them over to the users.
PURPOSE OF USE
The electronic battery charger can be used for the following purposes:
• charging 12-24V 16A batteries, 5Ah to 550Ah
• use on Lead, Wet or Gel - Agm – Lithium (LiFePO4) batteries
The electronic battery charger must not be used for the following operations:
• use on batteries other than 12V-24V 16A
• use outside the technical specifications contained in the TECHNICAL DATA table
• use in humid or wet environments, or in bad weather
• use for any applications other than stated ones
WORK AREA SAFETY
Do not operate the battery charger in environments containing potentially explosive atmospheres or inflammable
materials, because sparks may be generated, which can ignite the dust or fumes.
Keep children and bystanders away from your workplace while operating the battery charger. Distractions from other
people can cause you to lose control over the battery charger during use.
Do not inhale any harmful gases that may be released by the battery of the motor vehicle while working on the engine.
During connection operations, keep your face away from the motor vehicle battery. The battery contains corrosive
liquid; in the event of accidental contact with your skin or eyes, rinse immediately with water and seek medical advice.
Do not drop any metal tools on the motor vehicle battery: it may short-circuit.
Use the battery charger in a dry area, avoiding humidity.

BATTERY CHARGER SAFETY

- Before use, check that the battery charger has not been damaged, and that there are no uncovered cables or worn parts.
- Not use the battery charger when damaged, to avoid the risk of electric shocks; do not try to open or modify it.
- Connect the power supply cable of the battery charger to the mains socket, making sure that the mains voltage matches
the voltage stated on the power supply device. (See TECHNICAL DATA table).
- After use, do not leave the battery charger connected to the mains socket for a long time.
1498_16A.indd 11
EN
11
07/11/19 15:36