Technical Data - Beta 1498-16A Instrucciones

INSTRUCTIONS FOR USE
BATTERY CHARGER SAFETY
- Periodically check the battery charger, the power supply cable and the clamps.
- Do not use the battery charger when damaged, to avoid the risk of electric shocks; do not try to open or modify it.
- Connect the battery charger to the mains socket, making sure that the mains voltage matches that stated on the power supply
device. (See TECHNICAL DATA table).
- Do not cover the battery charger when using it. Allow adequate space for ventilation.
- Do not use the battery charger in humid or wet environments; do not expose it to rain. Wet and contaminated environments
increase the risk of electric shocks.
PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING BATTERY CHARGER
Failure to observe the following warnings may result in physical injury and/or disease.
ALWAYS WEAR SAFETY SHOES
ALWAYS WEAR EYE PROTECTION
ALWAYS WEAR PROTECTIVE GLOVES AGAINST PHYSICAL AGENTS WHILE
OPERATING BATTERY CHARGER
Additional personal protective equipment to wear according to the values found in the environmental
hygiene/risk analysis survey if the values exceed the limits under current regulations.

TECHNICAL DATA

FOR USE WITH BATTERIES
RATED VOLTAGE
CHARGING VOLTAGE
ABSORBED POWER
CAPACITÀ BATTERIA IN CARICA
CLAMP CABLE LENGTH
DEGREE OF PROTECTION
POWER SUPPLY CABLE LENGTH
DIMENSIONS
WEIGHT
1498_16A.indd 13
12-24V 16A da 5Ah a 550Ah
Batteries: Wet - AGM - LITIO LiFePO4
220-240V 50/60Hz
12 - 24V
390 Watt
5÷360 Ah
0.5 m
IP34
1.9 m
185x290x85 mm
1.9 kg
EN
13
07/11/19 15:36