Beta 1498-16A Instrucciones página 15

INSTRUCTIONS FOR USE
EN
1. Before starting to charge the battery, make sure that the power supply lead is not plugged into the mains.
2 2. Locate the vehicle's earthing point, which is normally connected to the negative battery terminal.
3. Charging a battery with negative terminal grounded to the vehicle's chassis.
• Connect the red clamp to the positive terminal (+) of the battery.
• Connect the black clamp to the vehicle's earthing point, keeping it away from the battery and the fuel pipe.
4. Charging a battery with positive terminal grounded to the vehicle's chassis.
• Connect the black clamp to the negative terminal (-) of the battery.
• Connect the red clamp to the vehicle's earthing point, keeping it away from the battery and the fuel pipe.
5. Using eyelet terminals.
• Connect the black eyelet terminal to the negative terminal (-) of the battery.
• Connect the red eyelet terminal to the positive terminal (+) of the battery.
• Make sure that the two eyelets are secured correctly to the battery terminals, so that they generate an optimal electrical contact.
• Secure the ends of the output leads with eyelets firmly in a position of the vehicle away from the fuel pipe (do not use clips in
metal or any other material that could damage the output lead).
Charging batteries that are not connected to a vehicle
1. Before starting to charge the battery, check that the power supply lead is not plugged into the mains.
2. Connect the red clamp to the positive terminal (+) of the battery.
3. Connect the black clamp to the negative terminal (-) of the battery.
CAUTION Make sure that both clamps of the output leads generate a suitable contact with their respective terminals.
HOW TO USE BATTERY CHARGER
1. Connect the output leads to the battery.
2. Plug the power supply lead of the battery charger into the mains, making sure the voltage matches the rated voltage of the
battery charger (230V-50Hz);
3. With the battery charger in "stand-by" mode and the ON LED lighting up, set the charging parameters suitable for the type of
battery to charge using the keys on the control panel.
The "Mode" key can be used to set the following modes: 12V, SHOW ROOM, SUPPLY and 24V
15
1498_16A.indd 15 07/11/19 15:36