Klarstein AMELIA Manual De Instrucciones página 29

Electrical connection
• Electrical wiring must be done by a qualified person(s) in accordance with all
applicable codes and standards.
• Turn off electrical power at service entrance before wiring.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
• Do not use the plug and an extension cord other than the ones initially supplied with
the hood.
• The earthing of this hood is compulsory. Do not remove ground prong of the plug.
Decorative telescopic chimney
• Bottom part:
Carefully slide the decorative
chimney bottom down outside the
decorative chimney top. Carefully
place the decorative chimney
bottom into the recessed area of
the hood body top then secure the
chimney to the chimney bracket is
well fixed on the wall with screws.
• Top part:
Raise the decorative chimney top
up inside the decorative chimney
bottom. Secure the decorative
chimney top to the chimney mounting bracket that is well fixed on the wall with the
two chimney bracket screws supplied from two sides.
EN
29