Key Automation SEL4 Instrucciones Y Advertencias Para Su Instalación Y Uso página 10

4.10 DELETION OF ALL USER PASSWORDS
DESCRIPTION
If you want to delete all user passwords you will need
to enter the master password and confirm it by pressing
the "F" key.
A beep will be heard every 2 seconds that invites us to
enter the command to delete all user passwords "6",
confirm it by pressing the key
A double beep will be heard every 2 seconds that
invites us to re-enter the master password; you have 10
seconds to start the insertion; at the end of the insertion,
confirm it by pressing the key
If the master passwords entered are the same, the
procedure for deleting all user passwords will begin,
then you will hear a short confirmation beep, in case of
error you will hear a long beep. Lighting will dim after 5
seconds.
4.11 DELETION OF ALL USER PASSWORDS AND MASTER
PASSWORD RESET
To delete the entire user password memory and reset the master password you will need to follow
these steps:
1. Turn off the automatic door.
2. Press and hold the PA button on the keyboard card.
3. Turn on the automatic door.
4. The DL1 LED will flash for 10 seconds after which the cancellation will begin.
5. At the end of the cancellation, the LED DL1 will remain on steady.
6. Release the PA button.
7. End of procedure.
4.12 EXECUTION OF A SERVICE
In order to run a service, you must enter one of the previously stored user passwords followed by
the confirmation key
execution of the service, while if incorrect you will hear a long beep; the illumination will dim after 5
seconds.
NOTES: Each time a key is pressed a short beep will be emitted and there will be an increase in
brightness for a maximum of 10 seconds; if no other keys are pressed a long beep will be emitted
and the lighting will dim.
.
.
. If the password entered is correct you will hear a short beep followed by the
EXAMPLE
12345678
6
12345678
BEEP
+ 2s + + 2s
+2s + +2s
<0.5s