Cameo cLscan60W Manual De Usuario página 10

oPERATIoN:
AUTo MoDE
Press the MODE button and then use the UP and DOWN buttons to select the
auto mode ("AUTO" appears in the display). Now press the ENTER button
and use the UP button to select the master mode (MAST) or the DOWN
button to select the stand-alone mode (ALON) and confirm with ENTER. The
display now reads "AU-M" for master mode or "AU-A" for stand-alone mode.
In master mode, additional scanners of the same type can be be used on the
master unit as slave units. Select the DMX mode for the slave unit and set
the DMX Start address to 001. Use a DMX cable to connect the slave unit(s)
to the master unit (master unit DMX OUT - slave unit DMX IN). Now the slave
unit follows the master unit.
In stand-alone mode, the scanner runs independently of other connected units.
REVERSE PAN
The PAN motion can be reversed using this function.
Press the MODE button and then use the UP and DOWN buttons to select the
reverse pan function ("r PAN" appears in the display). Now press the ENTER
button and use the UP button to select reverse on (ON) or the DOWN button
to select reverse off (OFF)
Confirm with ENTER.
REVERSE TILT
The TILT motion can be reversed using this function.
Press the MODE button and then use the UP and DOWN buttons to select the
reverse pan function ("r t I L" appears in the display). Now press the ENTER
button and use the UP button to select reverse on (ON) or the DOWN button
to select reverse off (OFF)
Confirm with ENTER.
10