Electrical Connection; Ec Declaration Of Conformity; Troubleshooting - Scheppach SLIK 7 Manual Del Usuario

m Electrical Connection
The installed electric motor is connected and is ready to
work.
The connection complies with the relevant VDE and DIN
regulations.
The customer-side network connection and the used ex-
tension line must comply with these provisions.
Installations, repair, and maintenance work relating to the
electric installation may only be performed by specialists.
Important notes
The electric motor is designed for operating mode S 1.
If the motor is overload it is turned off automatically. Af-
ter a (varying) cooling period the motor can be turned on
again.
m Maintenance
Slightly lubricate the work table before working. This fa-
cilitates the final cleaning of the work table.
Warning: Exclusively use original spare parts for the main-
tenance/service.
Disconnect the mains plug prior to each intervention in
the grinding machine.
General maintenance notes
The grinding machine must be cleaned carefully after each
deployment. Regularly lubricate all moveable parts. Treat
the work table with a thin layer of automotive type paste
wax. This facilitates the cleaning of the work table.
Problem
Motor does not start
Machine gets slower
during the work
Grinding belt runs off
the drive wheels.
Wood burns during the
grinding operation.
Trouble shooting
Possible Cause
a) ON/OFF switch damaged.
b) ON/OFF cable damaged.
c) ON/OFF relay damaged.
d) Fuse burnt-out.
e) Motor burnt-out.
An excessive pressure is exerted on the work
piece.
It does not run in the track.
a) Sanding disc or belt covered with
grease.
b) An excessive pressure is exerted on
the work piece.

EC Declaration of Conformity

We herewith declare, scheppach Fabrikation von Holzbearbeitungs-
maschinen GmbH, Günzburger Str. 69, D-89335 Ichenhausen that the
machine described below due to its con struc tion and design and in
the version delivered by us complies with the relevant provisions of
the following EC Directives.
In case of a modification of the machine this declara tion ceases to be
valid.
Machine description:
Belt grinding machine
Machine type:
SLIK 7, Art.-Nr. 8105 0901, 8105 0902, 8105 0902 10 FR
Relevant EC directives:
EC machine directive 98/37/EG (< 28.12.2009),
EC machine directive 2006/42/EG (> 29.12.2009),
EC Low voltage directive 2006/95/EWG,
EC-EMV directive 2004/108/EWG.
Applied harmonized European standards
EN12100-1, EN12100-2, EN13857, EN349, EN13850, EN847-1, EN13849-1,
EN1088, EN50082-1, EN60204-1,
EN60555-3, EN61029-1, EN61029-2-5
Notified body within the meaning of Annex VII
TÜV Rheinland, Product Safety GmbH, 51101 Köln
Engaged for:
EC design certification AM 500428140001, AM 500428170001
Place, date:
Ichenhausen, 12.11.2009
Signature:
On behalf of Wolfgang Windrich (product manager)
Help
a-d) Replace all damaged parts before you
use the grinding machine.
e) Contact your local service centre or
an authorized service station. Each
attempted repair may cause dangers if
not performed by a qualified expert.
Exert less pressure on the work piece.
Readjust the track.
a) Replace the belt or the disk.
b) Reduce the pressure on the work
piece.
EN55014, EN60555-2,
english 11