Basic Operations; Turning The Power On; Volume Control - Onkyo SBT-200 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Basic operations

Turning the power on

Press the
button
or
press the
button on the remote controller.
• The
indicator lights depending on the input source.
Note
If the power does not turn on, check whether the power cord is plugged in properly.
Setting the sound bar to standby mode (Bluetooth standby)
Press the
button again.
• The
indicator goes off.
Note
Auto power on function (P.16) is always activated in standby mode.
Volume auto fade-in
If the sound bar enters standby mode with the volume at higher level and is turned on again, the
volume will start at lower level and gradually increase to the last set level.
If the volume is set at relatively low level, Volume auto fade-in won't work.

Volume control

To increase and decrease the volume,
press the VOLUME+/VOLUME- button on the sound bar
or
press the VOLUME+/VOLUME- button on the remote controller.
Note
• Everytime the VOLUME+/VOLUME- button on the remote controller is pressed, the SURROUND
indicator flashes once.
• When the volume is maximum or minimum, the SURROUND indicator flashes.
Muting
Pressing the
button on the remote controller.
• The volume is muted temporarily. Press the
• When the volume is muted temporarily, the SURROUND indicator flashes.
button again to restore the volume.
En-14

Publicidad

Tabla de contenido
loading

Tabla de contenido