System Preparation - Onkyo SBT-200 Manual De Instrucciones

System preparation

To mount the sound bar on the wall
Caution:
• Be very careful to prevent the sound bar (2.4 kg)
from falling when mounting on the wall.
• Before mounting, check the wall strength. (Do
not put on the veneer plaster or whitewashed
wall. The sound bar may fall.) If unsure, consult
a qualified service technician.
• Mounting screws are not supplied. Use
appropriate ones.
• Check all wall mount angle screws for
looseness.
• Select a good location. If not, accidents may
occur or the sound bar may get damaged.
• Onkyo is not responsible for accidents
resulting from improper installation.
Driving screws
■
Onkyo designed the sound bar so you may hang
it on the wall. Use proper screws (not supplied).
See below for size and type.
3.2 mm
5 mm
Min. 22 mm
Installing the sound bar
■
1
Fix the pattern paper to the wall in
horizontal position as below.
509 mm
548 mm
Wall surface
44 mm
2
Make a hole on the wall following
the screw point marks on the pattern
paper by using a drill.
8-9 mm
Wall surface
9 mm
Pattern paper
(supplied)
32 mm
3
Fix a wall mount plug into the hole
using a hammer, until it is flush with
the wall surface.
8-9 mm
4
Fasten the screws to the wall as shown
below. (Total screw is 2 pieces.)
Wall surface
Wall surface
5
Hang the sound bar onto the screws.
Note
Refer to "When mounting on the wall" in "Falling
Prevention" (P.11).
En-9
32 mm
Wall surface
Screw using
Screwdriver
4.5mm - 5mm
Gap from wall
surface