GRABBER GR871 Manual De Instrucciones página 7

FENCE
FIG. 6
FENCE
BOLTS
FORWARD
CLAMP LEVER
FIG. 7
ANGLE
ADJUSTMENT
INDICATOR
SLOT
EDGE
FIG. 8
VISE
LEVER
VISE
CRANK
WHEEL
SQUARE
TRIGGER
SWITCH
5
fence is not locked. Lever will only lock fence when there is strong
resistance to moving it to rear. If resistance is light, adjust clamping
force by tightening slightly the two bolts holding the fence to the base.
Test by reclamping and attempt to move fence (see Figure 6).
Fence Angle Adjustment
Angle adjustment indicator is part of fence clamping system. Align
desired angle indicator line with edge of slot in base (see Figure 7). For
a more accurate square cut (Figure 7), disconnect power supply, unlock
fence, push arm down until wheel extends into base, place a square
against wheel, adjust fence against square, then lock fence into
position.
Switch
To start the tool, depress the trigger switch shown in Figure 8. To turn
the tool off, release the trigger switch. Keep hands and material from
wheel until it has coasted to a stop.
FIG. 9 FIG. 10
SPINDLE SHAFT
INTERNAL
THREAD
WHEEL LOCK LEVER
Removal and Installation of Wheels
1. Be sure tool is disconnected from power supply.
2. Push in wheel lock lever (Figure 9) and rotate wheel by hand until
wheel lock lever engages slot in inside flange to lock wheel. Loosen
WHEEL
M10
FLANGE,
FLANGE,
BOLT
OUTSIDE
INSIDE
FLAT
WASHER