Pinnacle Studio Deluxe Guía De Instalación Rápida página 17

When you preview with the scrubber and hold down the Alt key, the
transition plays at full resolution but--depending on your PC's capabilities--
may not play in real time. Again, this affects preview playback only. When
you Make Movie the transition is rendered at full resolution and frame rate.
3. Hard disks for capture
For video editing we recommend you use a second hard disk in your system
for capturing and playback. The hard disk must be capable of playing
reading and writing at a sustained rate of 4 MB per second. This can be a
fast EIDE hard disk. For best results, enable your hard disk as follows:
Open the Windows 98 SE Device Manager and click Drives, Settings and
enable the DMA checkbox.
4. DV Camcorder support
If you get an error message from Studio when you switch to capture mode,
you may have to make a special setting in Windows to support your
camcorder. From Windows device manager, select the "1394 Bus
Controller" device (OHCI Compliant IEEE 1394 Host Controller) and click
the "Properties" button. Go to the "Settings" tab. Check the box labeled
"Support Non-Compliant Devices". Now restart your computer. Windows
should detect your camcorder when it is plugged in and load the appropriate
DV camcorder drivers. This should allow Studio DV / Studio DVplus to
capture video from your camcorder.
5. SmartCapture and Analog sources
Preview quality capture is only available when capturing from a DV source.
Video captured from analog sources is always saved at full quality
6. SmartCapture on DV tapes with multiple timecode segments
When you use the SmartCapture feature by capturing in preview quality,
you must only capture a single timecode segment. If you have a blank spot
on your tape that causes the timecode to reset to zero, you need to capture
this section separately. When recapturing the video in full quality to make
the final movie, Studio uses timecode to locate the correct section of tape,
and if the timecode resets within a single capture it will not be possible to
do so. Studio automatically stops capturing (for preview-quality captures) if
a break in timecode is detected.
Quick Install Guide
15