Pinnacle Studio Deluxe Guía De Instalación Rápida página 6

Installing Pinnacle Studio Deluxe
Defragmenting the hard disk
Before installing and configuring the AVDV board, you should defragment
your hard disk/s. You find the Windows defragmentation utility under Start >
Programs > Accessories > System Tools > Disk Defragmenter.
SECTION 1: INSTALLING THE AVDV BOARD
In the interest of your own safety and to avoid damage to your AVDV board or
your computer, please pay special attention to the following:
•
Computer components are sensitive to static charge. Divert any
electrostatic charge from your person before touching the components with
your hands or any tools.
•
Before opening the computer make sure that the AC power plug is
disconnected.
To install the AVDV board into your computer:
1. Discharge any static electricity from your person by touching the
metal case of your computer.
2. Switch off the computer and all peripheral devices. Disconnect the AC
power cord and all necessary cables.
3. Loosen the screws of the computer's cover and remove the cover.
4. Select a free PCI slot.
5. Remove the slot shield at the back of the computer (see your
computer's user guide for specific directions).
6.
Insert the board carefully into the selected slot. Hold the board at the
top edge and push both ends simultaneously into the slot. Press the
board's top edge to ensure that the board is firmly seated in the slot.
If the board cannot be inserted without problems, do not force the
board into place (the contacts at the connector could bend). Instead,
pull the board out carefully and try again.
Studio Deluxe
4