For Your Safety - Beta 3014 Instrucciones

Beta
We recommend using this machine after reading the instruction manual carefully, keeping to the instructions
provided therein.
1. Do not exceed 750 kg load
2. Use bolts equal to or higher than class 8.8
3. Lock the rotation plane in position, before applying the weight
4. Make sure that the weight is well centred on the support and that its barycentre does not come out of the
support surface
5. Tighten the bolts and make sure that the weight is suitably held
6. Make sure that the points of support are suitable for the weight to carry
7. Make sure that the pin joining the two halves together is suitably fixed
8. Release the rotation flange after fitting in and grabbing the rotation lever
9. Do not work under the weight
10. Do not handle on uneven grounds or obstacles when loaded
11. Check the state of the support before using it; replace it if irreparable damage has been caused
12. Do not modify the product; do not weld it in any way
13. Before loosening the nuts that hold the weight, fasten it to suitable equipment
14. Failure to follow the above rules may result in severe damage or injury
Description:
This tool is designed to support the engine after it has been removed from the vehicle, so that it can be worked on
during extraordinary repairs. The support incorporates a flange for fixing and rotating the engine, to make overhauling
jobs easier, and a few high-load wheels, so that it can be easily moved in the rooms.
Pack contents*:
1. 2 pivoting wheels with brakes
2. 1 pivoting wheel
3. 2 fixed wheels
4. 4 rectangular plastic covers
5. 4 adapters for engine connection
6. 1 lever for rotating the engine
7. 1 flange for supporting and rotating the engine
8. 1 front beam
9. 1 rear beam
10. 1 central beam
11. 1 upper beam
12. 1 flange locking pin
13. 1 support locking pin
14. 1 safety pin
15. 4 full bolts M12X100 mm
16. 4 bolts M12X70
17. 1 full bolt M12x75
18. 2 full bolts M10X60 mm
19. 4 full bolts M12X50 mm
*The specifications of the product may change without notice
Assembly Instructions:
See figure 1. Lubricate the wheel pins and the support and rotation flange with grease.
Visual Check:
Before using the support, a thorough visual check is recommended. Make sure that there are no cracks around the
welds, signs of excessive rust, bent beams, missing parts or overworn wheels or pins.
Maintenance:
Periodically clean the support, lubricate the wheels with motor oil or grease, remove, clean and grease the rotation
flange.
INSTRUCTIONS
ART. 3014
Engine support

For your safety

GB