Storing And Caring For The Product - Imetec PIUMA CORDLESS N4001 Manual De Instrucciones

cleaning the dust container (7a)
• Pull the dust collection system release lever (8) [Fig. F1] and remove the dust collection
system (7) [Fig. F2].
• Extract the filtering system (7B+7C) [Fig. F3].
• Empty the dust collection compartment (7A) [Fig. F4].
• When necessary, rinse the dust collection compartment (7A) and let it dry completely.
• Refit the filtering system (7B+7C) in the dust collection compartment (7A) [Fig. F3].
• Insert the dust collection system (7) on the appliance by inserting the lower part into its
guide [Fig. F2].
• Press the upper part of the dust collection system (7) until it snaps into place, which
indicates that the dust collection system lever is properly locked (8).
cleaning and replacing the filtering system (8b+8c):
• Pull the opening lever of the dust collection compartment (8) [Fig. F1] and remove the
dust collection system (7) from the appliance [Fig. F2].
• Extract the filtering system (7B+7C) [Fig. F3].
• Detach the filter protective grille (7B) by turning it clockwise and removing it [Fig. F5].
• Clean the filter (7C) and the filter protective grille (7B) by shaking and brushing the dust
off with care. Use a soft brush to prevent any damage.
If suction power does not increase after cleaning the dust collection compartment (7A) and
the filtering system (7B and 7C), replace the filter (7C) with a new one.
noTe:
• replace the filter if damaged or impossible to be thoroughly cleaned.
• replace the filter at least once a year.
• Failure to clean or replace the filter will make the manufacturer's warranty null
and void.
Put the filtering system (7B+7C) back inside the dust compartment (7A) and reattach it to
the sweeper body, being careful to insert it in the relevant bottom seat and make the dust
collection system release lever click (8).
Warning! let the filters dry completely after washing them
for at least 24 hours before reassembly.
Warning! make sure all cleaned parts are completely dry
before reusing the appliance!

sToring anD caring For The proDUcT

If the appliance is not used, take the feeder out (4) and store the appliance in a dry and
dust-free place.
en
17