Mains Connection - Milwaukee M18 AF Manual Original

MAINS CONNECTION

Connect only to single-phase AC system voltage as indicated on
the rating plate. It is also possible to connect to sockets without an
earthing contact as the design conforms to safety class II.
Before doing any work on the device pull the plug out of the socket.
Make sure the machine is switched o before plugging in.
Before use check machine, cable and plug for any damages or
material fatigue. Repairs should only be carried out by authorised
Service Agents.
Keep mains lead clear from working range of the machine. Always
lead the cable away behind you.
Always disconnect the plug from the socket after use.
MAINTENANCE
The ventilation slots of the machine must be kept clear at all times.
If the replacement of the supply cord is necessary, this has to be
done by the manufacturer or his agent in order to avoid a safety
hazard.
Use only Milwaukee accessories and Milwaukee spare parts. Should
components need to be replaced which have not been described, please
contact one of our Milwaukee service agents (see our list of guarantee/
service addresses).
If needed, an exploded view of the tool can be ordered. Please state
the Article No. as well as the machine type printed on the label
and order the drawing at your local service agents or directly at:
Techtronic Industries GmbH, Max-Eyth-Straße 10, 71364 Winnen-
den, Germany.
SYMBOLS
CAUTION! WARNING! DANGER!
Please read the instructions carefully before starting the
machine.
Remove the battery pack before starting any work on
the appliance.
Before doing any work on the device pull the plug out of
the socket.
This tool is only suitable for indoor use. Never expose
tool to rain.
Quali ed for tropical climate up to 40°C ambient
temperature
Do not dispose of electric tools together with household
waste material. Electric tools and electronic equipment
that have reached the end of their life must be collected
separately and returned to an environmentally compatible
recycling facility. Check with your local authority or retailer
for recycling advice and collection point.
Class II tool. Tool in which protection against electric
shock does not rely on basic insulation only, but in which
additional safety precautions, such as double insulation or
reinforced insulation, are provided. There being no provi-
sion for protective earthing or reliance upon installation
conditions.
Class III tool.
European Conformity Mark
British Conformity Mark
Ukraine Conformity Mark
EurAsian Conformity Mark
Energy E ciency Level VI
Switch mode power supply unit
S
Degree of protection provided by enclosure
short-circuit-proof safety isolating transformer
Rated ambient temperature
Symbol indicating the positive/negative of output
terminal
GB D
Deutsch English
9