Indication Tone; Care And Maintenance; Faqs - Zipy GO EarAir Guía De Usuario

9. Indication tone

Indication tone
Two tones every 10 seconds
Three "DU" tones every 20
seconds

Care and maintenance

Read the following recommendations carefully before using EARAIR.
Following these you will be able to enjoy this product for many years.
Keep it dry and don't put it in the dump place to avoid the product's
internal circuit being affected.
Keep the product away from direct sunlight or hot places. High
temperatures will shorten the life of electronic devices, destroy the
battery or distort certain plastic parts.
Don't expose the product to cold areas. It may damage the internal circuit
board.
Don't try to disassemble the product as it may get damaged if you are not
professional.
Don't let it fall down onto the floor or other hard surfaces. The internal
circuit might get damaged.
Don't use intensive chemical products or detergent to clean the product.
Don't scratch the surface with sharp things.
In case the product doesn't function properly, send it to the store you bought
it. The staff will help you to solve the problem

FAQs

1. What does it mean when red LED is on ?
Battery is low power, need to be recharged.
2. Why is not the red LED on when charging?
a) Please make sure the charging device connect with headset Well;
b) You didn't use the headset for a long time, the battery may dry up. At this
time, you have to charge the battery for 30 minutes, and then the red
LED will be ON.
Status of the headset
Conversation mode and microphone
mute
Low power
11