Beta 1843BM Instrucciones página 6

Electrical connection: in cable reels with transformers the working voltage of
the light source is 24 V; whereas the input voltage must be 230 V.
An overload protection system is available on the models complete with tran-
sformers to disconnect the power supply from the lamp if an e cess of current
– which might affect safety – should occur.
If the protection system should be
operated the cause may be checked
by trained personnel only. After the
check has been completed and initial
safety conditions have been restored
the protection system can be reset by
pressing the key shown in Fig. 3.
Electrical connection: in 230 V cable reels with lamp holders without transfor-
mers the nominal voltage of the light source must always match the voltage of
the power supply mains the cable reel is connected to.
Loading capacity: cable reels with lamp holders can support a ma imum load of
60W at 230V (1843BM; 1843WBM; 1844ABM; 1846ABM). Or 25W at 24V (1844BM;
1846BM).
With e tension cable 1848 the ma imum load is 1600W at 230V with completely
unwound cable. With wound cable the loading capacity is ust 1200 W because of
reduced loss of heat.
WARRANTY:
12 months from date of purchase – The warranty consists in free repairs or replace-
ments at our headquarters – The warranty does not cover replacements or repairs of
any parts subject to normal wear and tear as the result of operation – The warranty
will not apply if the device is damaged through misuse
6
24 V cable reels with transformers
230 V cable reels
3