Yakima Q103 Manual Del Usuario

This Yakima application is a little different than the Q clips referred to in your
Q Tower instructions. The M2 measurement (front bar) and M4 measurement
(rear bar) are not necessary because these vehicles have mounting posts
installed by the car maker and are not adjustable.
Before you begin—
Find the mounting posts under the
rubber trim on your vehicle. The
front and rear posts are located
approximately 6 and 36 inches from
your windshield, respectively.
Attach towers to front and rear crossbars using the M1 and M3
measurements listed below. Follow steps 1–6 in your Q Tower instructions.
YEAR MAKE/MODEL
99-06 VW Golf/GTI 3dr
99-06 VW Golf 5dr
99-05 VW Jetta 4dr
07-10 VW City Golf 5dr
07-09 VW City Jetta 4dr
With car doors open, gently place front bar assembly over front mounting
posts and rear bar assembly over rear mounting posts.
Center racks so the distance from door frame to Tower base is equal on
both sides of car.
Install Clips. Follow steps 9 and 10 in
your Q Tower instructions.
Slide Clip Tower
assemblies down
onto the posts as
pictured.
Tighten rack frequently. Failure to do so can cause ejection.
Remove Rack when not in use to prevent damage to the internal door trim.
TIGHTEN and TEST each Tower as directed in steps 11-15 in the Q Tower instructions.
1031978G - 1/5
103
M1 (front) M3 (rear)
35-1/4" NOTE
35" 32-1/4"
35-1/4" 32-1/2"
35" 32-1/2"
35" 32-1/2"
NOTE: Follow the Q-34 instructions for rear clips.
Check to ensure clips remain in forward postion.
NOTES
54, 61, 82, 114, 132, 144, 156, 191, 197
61, 82, 132, 144, 187, 191, 197
54, 61, 82, 144, 187, 191, 197
54, 61, 82, 132, 144, 182, 187,191, 197
54, 61, 82, 144, 182, 187, 191, 197
Pull back rubber trim to reveal a pair
of front mounting posts.
FRONT of car
Slide Clip Tower
assemblies FORWARD
until they stop.
Repeat steps 4 and 5 on
other 3 Towers.
Q103
A
M1
and
M3
Part #1031978 Rev.G